To contribute to this page, edit the following file
Lidl HG06338 #
| Model | HG06338 |
| Vendor | Lidl |
| Description | Silvercrest 3 gang switch, with 4 USB (EU, FR, CZ, BS) |
| Exposes | switch (state), linkquality |
| Picture |  |
Notes #
Pairing #
Factory reset the 3 gang switch by holding the power button for 5 seconds. When you let go of the button an LED should blink. After resetting the 3 gang switch will automatically connect.
While pairing, keep the 3 gang switch close to the adapter.
Node-Red #
How to use the connector strip with Node-Red: Use the “command node” of the node-red-contrib-zigbee-package. Drop-down-lists are helping you with the configuration.
Exposes #
Switch (l1 endpoint) #
The current state of this switch is in the published state under the state_l1 property (value is ON or OFF).
To control this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state_l1": "ON"}, {"state_l1": "OFF"} or {"state_l1": "TOGGLE"}.
To read the current state of this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"state_l1": ""}.
Switch (l2 endpoint) #
The current state of this switch is in the published state under the state_l2 property (value is ON or OFF).
To control this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state_l2": "ON"}, {"state_l2": "OFF"} or {"state_l2": "TOGGLE"}.
To read the current state of this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"state_l2": ""}.
Switch (l3 endpoint) #
The current state of this switch is in the published state under the state_l3 property (value is ON or OFF).
To control this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state_l3": "ON"}, {"state_l3": "OFF"} or {"state_l3": "TOGGLE"}.
To read the current state of this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"state_l3": ""}.
Linkquality (numeric) #
Link quality (signal strength).
Value can be found in the published state on the linkquality property.
It’s not possible to read (/get) or write (/set) this value.
The minimal value is 0 and the maximum value is 255.
The unit of this value is lqi.