To contribute to this page, edit the following file

Konke 2AJZ4KPFT #

Model	2AJZ4KPFT
Vendor	Konke
Description	Temperature and humidity sensor
Exposes	temperature, humidity, battery, linkquality
Picture

Notes #

Device type specific configuration #

How to use device type specific configuration

• temperature_precision: Controls the precision of temperature values, e.g. 0, 1 or 2; default 2. To control the precision based on the temperature value set it to e.g. {30: 0, 10: 1}, when temperature >= 30 precision will be 0, when temperature >= 10 precision will be 1. Precision will take into affect with next report of device.

• temperature_calibration: Allows to manually calibrate temperature values, e.g. 1 would add 1 degree to the temperature reported by the device; default 0. Calibration will take into affect with next report of device.

• humidity_precision: Controls the precision of humidity values, e.g. 0, 1 or 2; default 2. To control the precision based on the humidity value set it to e.g. {80: 0, 10: 1}, when humidity >= 80 precision will be 0, when humidity >= 10 precision will be 1. Precision will take into affect with next report of device.

Important #

Konke devices only work on Zigbee channel 15, 20 and 25.

Exposes #

Temperature (numeric) #

Measured temperature value. Value can be found in the published state on the temperature property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is °C.

Humidity (numeric) #

Measured relative humidity. Value can be found in the published state on the humidity property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is %.

Battery (numeric) #

Remaining battery in %. Value can be found in the published state on the battery property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 100. The unit of this value is %.

Linkquality (numeric) #

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.