TuYa TS0601_co2_sensor

ModelTS0601_co2_sensor
VendorTuYa
DescriptionNDIR co2 sensor
Exposesco2, linkquality
PictureTuYa TS0601_co2_sensor

Options

How to use device type specific configuration

  • temperature_precision: Number of digits after decimal point for temperature, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • temperature_calibration: Calibrates the temperature value (absolute offset), takes into effect on next report of device. The value must be a number.

  • humidity_precision: Number of digits after decimal point for humidity, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • humidity_calibration: Calibrates the humidity value (absolute offset), takes into effect on next report of device. The value must be a number.

  • co2_precision: Number of digits after decimal point for co2, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • co2_calibration: Calibrates the co2 value (absolute offset), takes into effect on next report of device. The value must be a number.

  • voc_precision: Number of digits after decimal point for voc, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • voc_calibration: Calibrates the voc value (absolute offset), takes into effect on next report of device. The value must be a number.

  • formaldehyd_precision: Number of digits after decimal point for formaldehyd, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • formaldehyd_calibration: Calibrates the formaldehyd value (absolute offset), takes into effect on next report of device. The value must be a number.

  • pm25_precision: Number of digits after decimal point for pm25, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • pm25_calibration: Calibrates the pm25 value (absolute offset), takes into effect on next report of device. The value must be a number.

Exposes

Co2 (numeric)

The measured CO2 (carbon dioxide) value. Value can be found in the published state on the co2 property. It's not possible to read (/get) or write (/set) this value. The unit of this value is ppm.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It's not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.