Sercomm SZ-ESW02

ModelSZ-ESW02
VendorSercomm
DescriptionTelstra smart plug 2
Exposesswitch (state), power, linkquality
PictureSercomm SZ-ESW02

Notes

Pairing

With the device unplugged (or socket switched off), press and hold the pairing button for ~4 seconds. Continue holding the pairing button while plugging in the device (or switching the socket on) and continue to hold while the LED has been illuminated (in 4 seconds). The sensor shall the wipe any knowledge of the previous network and other configuration parameters and begin searching for a new network (Auto Joining State).

Exposes

Switch

The current state of this switch is in the published state under the state property (value is ON or OFF). To control this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state": "ON"}, {"state": "OFF"} or {"state": "TOGGLE"}. To read the current state of this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"state": ""}.

Power (numeric)

Instantaneous measured power. Value can be found in the published state on the power property. It's not possible to read (/get) or write (/set) this value. The unit of this value is W.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It's not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.