To contribute to this page, edit the following file

Lonsonho 11830304 #

Model 11830304
Vendor Lonsonho
Description Curtain switch
Exposes cover (state, position), moving, calibration, motor_reversal, backlight_mode, calibration_time, linkquality
Picture Lonsonho 11830304

Notes #

Device type specific configuration #

How to use device type specific configuration

Exposes #

Cover #

The current state of this cover is in the published state under the state property (value is OPEN or CLOSE). To control this cover publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state": "OPEN"}, {"state": "CLOSE"}, {"state": "STOP"}. It’s not possible to read (/get) this value. To change the position publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"position": VALUE} where VALUE is a number between 0 and 100.

Moving (enum) #

Value can be found in the published state on the moving property. It’s not possible to read (/get) or write (/set) this value. The possible values are: UP, STOP, DOWN.

Calibration (binary) #

Value can be found in the published state on the calibration property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"calibration": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"calibration": NEW_VALUE}. If value equals ON calibration is ON, if OFF OFF.

Motor_reversal (binary) #

Value can be found in the published state on the motor_reversal property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"motor_reversal": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"motor_reversal": NEW_VALUE}. If value equals ON motor_reversal is ON, if OFF OFF.

Backlight_mode (enum) #

Value can be found in the published state on the backlight_mode property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"backlight_mode": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"backlight_mode": NEW_VALUE}. The possible values are: LOW, MEDIUM, HIGH.

Calibration_time (numeric) #

Calibration time. Value can be found in the published state on the calibration_time property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is S.

Linkquality (numeric) #

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.