To contribute to this page, edit the following file

Moes BHT-002-GCLZB #

Model BHT-002-GCLZB
Vendor Moes
Description Moes BHT series Thermostat
Exposes lock (state), deadzone_temperature, max_temperature_limit, climate (current_heating_setpoint, local_temperature, local_temperature_calibration, system_mode, running_state, preset, sensor), linkquality
Picture Moes BHT-002-GCLZB

Notes #

Pairing #

Switch the thermostat off. Press and hold the temperature down button for +- 8 seconds to enable the pairing mode (display lights up and a WiFi-like icon is blinking). After successful interview turn the thermostat on again.

Stop message flooding #

This unit has a bug that makes it send multiple messages when updating. To stop this from flooding your MQTT Queues, please add the following to your configuration.yaml file:

devices: ‘0x12345678’: friendly_name: thermostat debounce: 1

Exposes #

Lock #

The current state of this lock is in the published state under the child_lock property (value is LOCK or UNLOCK). To control this lock publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"child_lock": "LOCK"} or {"child_lock": "UNLOCK"}. It’s not possible to read (/get) this value.

Deadzone_temperature (numeric) #

The delta between local_temperature and current_heating_setpoint to trigger Heat. 1-5. Value can be found in the published state on the deadzone_temperature property. It’s not possible to read (/get) this value. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"deadzone_temperature": NEW_VALUE}. The unit of this value is °C.

Max_temperature_limit (numeric) #

Maximum temperature limit. Value can be found in the published state on the max_temperature_limit property. It’s not possible to read (/get) this value. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"max_temperature_limit": NEW_VALUE}. The unit of this value is °C.

Climate #

This climate device supports the following features: current_heating_setpoint, local_temperature, local_temperature_calibration, system_mode, running_state, preset, sensor.

Linkquality (numeric) #

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.