Touchlink #

NOTE: This is an experimental feature, for an ongoing discussion see: #2396

Touchlink is a feature of Zigbee which allows devices physically close to each other to communicate with each other without being in the same network.

Note that not all Zigbee devices support Touchlink, but most bulbs of common brands like Philips and IKEA support this.

Factory reset device #

Zigbee2mqtt allows to factory reset devices through Touchlink. This is especially handy for e.g. Philips Hue bulbs as they cannot be factory resetted by turning them on/off 5 times. Demo: video

To factory reset a device through Touchlink bring the device close (< 10 cm) to your coordinator (e.g. CC2531 adapter). After this send a MQTT message to zigbee2mqtt/bridge/config/touchlink/factory_reset with an empty payload.

Zigbee2mqtt will now start scanning, this can take up to 1 minute and during this scan your network cannot be used. After some time the device will identify itself (e.g. a bulb will start to blink).

Now that your device has been factory reset, it will automatically join Zigbee2mqtt (make sure that joining is enabled through permit_join: true). If it doesn’t, try powering the bulb off and on 1 time.